• Go-No-Go Gauge, NP34


    Go-No-Go Gauge
    The NIBCO® PEX go-no-go gauge tool is used to check a crimp joint for a proper connection. The go-no-go gauge is used with copper crimp rings and copper sleeves to check a crimp joint. If a crimp is done properly, the joint will fit the "go" side of the gauge. If a crimp is done improperly, or the crimp tool is not calibrated, the joint will fit the "no" side of the gauge. Please refer to NIBCO technical data sheets and catalogs for engineering and installation information.

    • Used with copper crimp ring and copper sleeve joints
    • Size range 3/8" to 1-1/4"
    SizeDescriptionUPCNIBCO #
    NP34S GO NOGO GAUGE SS SLEEVES ALL SIZE039923365675PX01369
    1NP34GNG 3/8, 1/2, 3/4, 1 GO/NO GO GAUGE039923271921PX01384

    For Warranty information regarding this product, please contact NIBCO Technical Support (Toll-Free) 888.446.4226

    Default How to Order copy will go here.

    TECHNICAL ASSISTANCE

    Engineers, contractors, wholesalers or manufacturers may obtain special or technical assistance from any factory representative of NIBCO. Write, fax or phone.

    NIBCO INC.
    World Headquarters
    1516 Middlebury Street
    Elkhart, IN 46516-4740
    USA

    PH: 1.574.295.3000 or 1.888.446.4226
    FAX: 1.574.295.3307 or 1.888.336.4226